Eazi Grip

Racing products

Lorem Ipsum is simply dummy text of the printing and typesetting industry. Lorem Ipsum has been the industry’s standard dummy text ever since the 1500s, when an unknown printer took a galley of type and scrambled it to make a type specimen book. It has survived not only five centuries, but also the leap into electronic typesetting, remaining essentially unchanged. It was popularised in the 1960s with the release of Letraset sheets containing Lorem Ipsum passages, and more recently with desktop publishing software like Aldus PageMaker including versions of Lorem Ipsum.

Eazi-Grip™ and Eazi-Guard™ riders had record breaking success at the 2017 IOM TT with 6 race wins, 14 podiums and over 30 top ten finishes in 8 races. Supported riders took the top step of the podium in the PokerStars Senior TT, RST Superbike TT, RL360 Quantum Superstock TT, Monster Energy Supersport TT and in both Race 1 & 2 of the Sure Sidecar TT. The same products we supply to leading teams around the racing world are available for purchase to everyone. For the best performance tank grip check out our Eazi-Grip range and for stone chip protection or to eliminate damage to your bike’s bodywork try Eazi-Guard.

Racing products Application Guide

Careful preparation and application will ensure maximum performance in all environments and will ensure 100% satisfaction with your purchase.

  • 1Clean surface thoroughly

    Clean surface thoroughly. Use an IPA cleaner to remove all surface contaminants. Do not use methylated spirits/petrol/lighter fluid etc, as they leave behind a thin greasy residue.

  • 2Ensure prepared surface...

    Ensure prepared surface is above 10°C. Heat up the Eazi-Grip tank pad and the tank on your bike with a heat gun or hair dryer for the best results

  • 3Peel back part...

    Peel back part of the release liner then press the tank grip firmly onto the tank and slowly peel back the liner whilst applying the pad. Push down between the traction domes and take care not to trap air bubbles as you go. Apply using firm pressure as our adhesive is pressure sensitive. Once applied press down firmly taking extra care at the edges.

Common Application Errors

  • Surface is prepared using incorrect cleaner.
  • Surface is cleaned using inappropriate material.
  • Surface has recently been sprayed, painted. has new transfers or new logos.
  • Surface is below application temperature.
  • Tank grip is below application temperature.
  • Surface has protective wax/polish/coating.
  • Incorrect pressure applied during application.
  • Tank grips used before full adhesive bond has formed.

Application Video

Gallery

Disclaimer: Motorsports are dangerous activities and could cause injury or death. Eazi-Grip™ / Eazi-Guard™ assumes no responsibility for damage or injury caused by this product. It is the responsibility of the user to determine both the suitability of the product and the correct application. Tank grips work on the principle of creating extra friction between the rider and tank and a degree of wear should be expected to both the riders leathers and the tank grips.

© 2017 Eazi-Grip   All Rights Reserved